W1209 DC12V Digital Cool Heat temp Thermostat Thermometer Temperature Control On/Off Switch -50-110C Temperature Control Switch

DESCRIPTION:

Model: W1209
Dimensions: 48 * 40mm
Temperature control mode: ON / OFF
Temperature range :-50-110 
ResolutionWhen temperature is 0.1 the resolution is -9.9~99.9, other temperature segment is 1
Control accuracy: 0.1 
Hysteresis accuracy: 0.1
Refresh rate: 0.5S
High temperature protection 0-110
Supply voltage: for DC 12V
Static current: ≤ 35MA, attract current ≤ 65MA
Output voltage: for DC 12V
Output power: 10A relay 
Measurement input: NTC (10K 0.5%) Waterproof Sensor
Environmental requirements: -10 ~ 60 Humidity 20% -85%

-50~110C DC 12V Digital LCD Temperature Controller Heat Cool Temp Thermostat Thermometer Regulator + Sensor WKQ001-P3437

Feature:
 
Mini size, high quality temperature controller, Wide temperature measuring range, -50~+110 Degree Centigrade
With large and clear LED display for better readability
Multiple functions, such as Heating and Cooling control, Temperature Calibration function, Delay protection function
All parameters can be set to default setting after short circuit
Can be used for domestic freezer, water tanks, refrigerator, industrial chiller, boiler, steamer, industrial equipments and other temperature-controlled systems
Specification:
Input Voltage: DC 12V
Control Range: -50~110 Degree Centigrade
Resolution:
-9.9~99.9 Degree C: 0.1 Degree C
Else Range: 1 Degree C
Control Accuracy: 0.1 Degree C
Temperature Accuracy: 0.2%FS
Refresh Rate: 0.5s
Measurement Input: NTC(B3950=10K 0.5%)waterproof sensor (Cable Length: 1 meter)
Output: Output Switch, Max. 10A
Environment Requirement: -30~60 Degree C
Humidity: 20%~85%
Parameter Setting (P0~P8):
-P0Cooling / Heating mode
-P1: Backlash Setting
-P2:Highest Range Setting
-P3:Lowest Range Setting
-P4:Temperature Calibration
-P5:Delay Start Time
-P6:High Temperature Alarm 
-P7: Data Lock Switch 
-P8: Restore Factory Settings
Size:
-Complete Size: 77 x 35 x 88mm
-Open-pore Size: 70.5 x 29mm
Usage:
Long-press "Set" button for 5 seconds to enter the internal parameter setting, then press Up/Down button to adjust P0~P8, and press "Rst" to Confim & Back.