AT24C256 24C256 Kbit Serial I2C Bus EEPROM IC DIP.This device is capable of both random and sequential reads up to the 256K boundary.sequential reads up to the 256K boundary. Functional address lines allow up to eight devices on the same bus, Functional address lines allow up to eight devices o..
Low-voltage, high-performance CMOS 8-bit microcomputer with 2KB of flash programmable and erasable read-only memory. The device is manufactured using Atmel high-density nonvolatile memory technology and is compatible with the industry-standard MCS-51 instruction set. This versatile 8-bit CPU with fl..
Features:
High performance, low power Atmel® AVR® 8-bit microcontroller
Advanced RISC architecture
131 powerful instructions – most single clock cycle execution
32 × 8 general purpose working registers
Fully static operation
Up to 20 MIPS throughput at 20MHz
On-chip 2-cycle..
FEATURES:
Operating Voltage: 1.8 to 5.5 V.
Flash memory: 16 Kb.
EEPROM: 512 Byte.
SRAM: 1K.
I/O pin: 32 pin.
USART protocol interface.
I2C protocol interface.
SPI protocol interface.
APPLICATIONS:
It is used in Arduino boards.
It can also use in any AVR microcontroll..
The ATmega16A is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. It has 16K bytes of In-System Programmable Flash Program memory with Read-While-Write capabilities, 512 bytes EEPROM, 1K byte SRAM. By executing powerful instructions in a single clock cycle, the ATm..
Features:
High-performance, Low-power AVR 8-bit Microcontroller
Advanced RISC Architecture
131 Powerful Instructions - Most Single Clock Cycle Execution
32 x 8 General Purpose Working Registers
Up to 6 MIPS Throughput at 16MHz
Fully Static Operation
On-chip 2-cycle Multipli..
Features:
High-performance, Low-power AVR 8-bit Microcontroller
Advanced RISC Architecture
131 Powerful Instructions - Most Single Clock Cycle Execution
32 x 8 General Purpose Working Registers
Up to 16 MIPS Throughput at 16MHz
Fully Static Operation
On-chip 2-cycle Multipl..
FEATURES:
High Performance, Low Power AVR® 8-Bit Microcontroller
Advanced RISC Architecture
131 Powerful Instructions – Most Single Clock Cycle Execution
32 x 8 General Purpose Working Registers
Fully Static Operation
Up to 20 MIPS Throughput at 20 MHz
On-chip 2-cycle Multi..
Features:
28-pin AVR Microcontroller
Flash Program Memory: 8 kbytes
EEPROM Data Memory: 512 bytes
SRAM Data Memory: 1 kbytes
I/O Pins: 23
Timers: Two 8-bit / One 16-bit
A/D Converter: 10-bit Six Channel
PWM: Three Channels
RTC: Yes with Separate Oscillator
MSSP: SPI and I²C..
The AT89S52 is a low-power, high-performance CMOS 8-bit microcontroller with 8K bytes of in-system programmable Flash memory. The device is manufactured using Atmel’s high-density nonvolatile memory technology and is compatible with the industry-standard 80C51 instruction set and pinout. The on-chip..
DESCRIPTION:
Atmel ATTINY45-20PU is tiny little 8pin DIP microcontroller, packed with high performance, low power 8 bit Advanced RISC Architecture. Its operational Voltage limit is 2.7V to 5.5V. It has 20 MHz CPU Clock, 6 general purpose I/O lines, 4KB ISP flash memory, 256B EEPROM, 256-Byte SR..
DESCRIPTION:
The ILN2003A are monolithic high-voltage, high-current Darlington transistor arrays. Each consists of seven n-p-n Darlington pairs that feature high-voltage outputs with commoncathode clamp diodes for switching inductive loads. The collectorcurrent rating of a single Darlington pair ..
General Description:
The P89V51RD2 is 80C51 microcontrollers with 64 kB flash and 1024 B of data RAM.
A key feature of the P89V51RD2 is its X2 mode option. The design engineer can choose to run the application with the conventional 80C51 clock rate (12 clocks per machine cycle) or sel..
The PIC12F508/509/16F505 devices from Microchip Technology are low-cost, high-performance, 8-bit, fullystatic, Flash-based CMOS microcontrollers. They employ a RISC architecture with only 33 single-word/single-cycle instructions. All instructions are single cycle (200 µs) except for program branches..
Features:
High-Performance RISC CPU
Only 35 single word instructions to learn
All instructions are single cycle (1µs) except for program branches
Operating speed: DC - 20MHz clock input
Interrupt Capability
8-Level Deep Hardware Stack
Direct, Indirect and Relative Addressing Mod..
The Low Pin-count (8) PIC® Flash microcontroller products offer all of the advantages of the well recognized mid-range x14 architecture with standardized features including a wide operating voltage of 2.0-5.5 volts, on-board EEPROM Data Memory, and nanoWatt Technology.
Standard analog peripheral..
Features:
High-Performance RISC CPU:
Only 33 Single-Word Instructions to Learn
All Single-Cycle Instructions Except for Program Branches, which are Two-Cycle
12-Bit Wide Instructions
2-Level Deep Hardware Stack
Direct, Indirect and Relative Addressing modes for Data and Instructio..
DESCRIPTION:
This powerful (200 nanosecond instruction execution) yet easy-to-program (only 35 single word instructions) CMOS FLASH-based 8-bit microcontroller packs Microchip's powerful PIC® architecture into an 18-pin package and is upwards compatible with the PIC16F628, PIC16C62XA, PIC16C5X an..
PIC16F676 - 14-pin Flash 1kB Microcontroller with ADCSpecifications14-pin Low Power MicrocontrollerFlash Program Memory: 1024 bytesEEPROM Data Memory: 128 bytesSRAM Data Memory: 64 bytesI/O Pins: 12Timers: One 8-bit / One 16-bitA/D Converter: 10-bit 8-ChannelFeaturesHigh-Performance RISC CPU:Sp..
Features:
28-pin Low Power Microcontroller
Flash Program Memory: 2048 bytes
SRAM Data Memory: 128 bytes
I/O Pins: 22
Timers: Two 8-bit / One 16-bit
A/D Converter: 8-bit Five Channel
PWM: 10-bit
SSP: SPI and I²C Support
External Oscillator: up to 20MHz
Specifications:
..
Features:
Special Microcontroller Features
100,000 erase/write cycle Enhanced Flash program memory typical
Self-reprogrammable under software control
Single-supply 5V In-Circuit Serial Programming
Watchdog Timer (WDT) with its own on-chip RC oscillatpr
Programmable Code Protection..