SPECIFICATION:
Voltage: AC 220V
Maximum power: 10000W (connected resistive load, 220VAC) Practically Use on 50% capacity means 5000W
Voltage regulation: AC 10V to 220VAC
Dimension: 130 x 60 x 47mm
Rated current: 25A MAX 45A
For electric furnace, water heater, lamps, small motor,..
DESCRIPTION:
motor brush controller for Electric bicycle & scooter
rated voltage: dc 24 v
Current limit : 22A
rated power: 250 w
matching motor: dc brushed motor
Under Voltage Protection: 20V
Wires Interface Definition
Battery :Thick Black (Power Negative) /Thick Re..
SPECIFICATIONS:
Voltage: DC 24V
Wattage: 350W
Undervoltage: 20+/0.5V
Handle: 1-4v
Dimension: 81 x 65 x 38mm/3.18 x 2.56 x 1.5"
Casing material: Aluminium
FEATURES:
* Wiring:
1. black & yellow connector - Brake wire
2. red & black connecotr - Charging port
3. ..
DESCRIPTION:
This is brush motor controller
Suitable Voltage:36v
Match Motor:36V 350W
Protection:31.5±0.5V
Speed Regulator 1-4 V(Throttle )
This item Suitable for electric bike & scooter
WIRING INSTRUCTIONS:
for example, in order to work at least the motor can be connect..
SPECIFICATIONS:
Name: 36V 800W Electric Scooter Bicycle E-bike Brush DC Motor Speed Controller
Material:aluminum
Size: 9cm x 6.5cm x 4cm
Power: 800W
Input: 36V
Undervoltage: 31.5 + -0.5V
Turning: mechanical normally open
Applicable motor: 500W-800W motor
Use of models: ele..
DESCRIPTION:
Speed controller for DC Motor, up to 500w, 48Volts. This controller may be used for replacement of most Electric tricycle and other kinds of electric scooters, E-bikes, or E-ATVs. Check that voltage is compatible, motor is of same or less watts and for similarity in size, shape and c..
DESCRIPTION:
Speed controller for DC Motor, up to 800w, 48Volts. This controller may be used for replacement of most Electric tricycle and other kinds of electric scooters, E-bikes, or E-ATVs. Check that voltage is compatible, motor is of same or less watts and for similarity in size, shape and c..
DESCRIPTION:
Speed controller for DC Motor, up to 500w, 24Volts. This controller may be used for replacement of most Electric tricycle and other kinds of electric scooters, E-bikes, or E-ATVs. Check that voltage is compatible, motor is of same or less watts and for similarity in size, shape and c..
The ATmega16A is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. It has 16K bytes of In-System Programmable Flash Program memory with Read-While-Write capabilities, 512 bytes EEPROM, 1K byte SRAM. By executing powerful instructions in a single clock cycle, the ATm..
FEATURES:
Support for the Arduino IDE 1.0+ (OSX / Win / Linux)
Power via USB or External Source - 5V or 7 - 35V (automatic selection)
On-board 500ma 5V Regulator
Built-in USB (and serial debugging)
6 I/O Pins (2 are used for USB only if your program actively communicates over USB, othe..
KEY FUNCTIONS:
1. Mode Key: Control dynamic modes.
2. Light Key: Control static colors ,
3. Speed key: Function adjustment key, it can adjust the speed level of the dynamic modes and the brightness level of the static colors
4. Speed ke..
DESCRIPTION:
100% Brand New and High Quality
The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak).
Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop.
The two mo..
DESCRIPTION:
Works in the frequency range of 2.405 to 2.475GHz.This band has been divided into 142 independent channels,each radio system uses 16 different channels and 160 different types of hopping algorithm.Silm design on transmitter for easy handling!
This radio system uses a high gain a..
FEATURES:
1.2 HG7881 chip on board motor control.
2.The module can simultaneously drive two DC motors or a 4-wire two-phase stepper motor.
3.The module input voltage: 2.5-12V
4.Each channel has a 800mA continuous output current capability.
5.PCB dimensions: &nb..
DESCRIPTION:
A single module can drive a 8x8 dot matrix common cathode
Operating Voltage: 5V
A single module can drive a 8x8 dot matrix common cathode
Operating Voltage: 5V
Dimensions: 12.8X12.8X1.3cm/
Fixing screws with 64 holes with a diameter 3mm
Module with input and output int..
DESCRIPTION:
100% brand new and high quality
Item color: white
Auto memorize function
Single color dynamic modes
Work Voltage : 12V DC
SPECIFICATION:
Control: Brightness, flashing, flashing modes
Button:3 Keys
Used for:Single color led strip(5050,3528,5630)
..
DESCRIPTION:
This is a breakout board for Freescale's MPR121QR2 The MPR121 is a capacitive touch sensor controller driven by an I2C interface The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode The MPR121 also features eight LED driving... pins. Wh..
DESCRIPTION:
100% Brand New and High Build Quality
The device also can be used as a signal generator for electric speed controller (ESC), then you can test your motor system without using a transmitter and receiver.
There are 3 modes to check servos or ESC:
Man..
DESCRIPTION:
This is a Quartz Crystal which is used to provide clock source to your microcontroller.
Every Microcontroller has inbuilt oscillator circuit, connecting this quartz crystal with microcontroller forms the crystal oscillator circuit which provide the desired frequenc..
DESCRIPTION:
Imported high-speed microcontroller, precise Intelligent Control
Three window display at a glance
Setting is simple, easy to operate
Wide Range -9 ~ 99 ℃ arbitrarily set
Space for a variety of temperature control, temperature control, incubators, etc.
FEATURES:
&nb..