DESCRIPTION:
3D Heatbed MK2a is currently the best construction of its kind on the market. Check it out yourself! It was proven by thousands of satisfied users. The maximum temperature which can be reached is 120°C and the device heats up from 0°C to 100°C in 5 minutes at..
Features:
High-performance, Low-power AVR 8-bit Microcontroller
Advanced RISC Architecture
131 Powerful Instructions - Most Single Clock Cycle Execution
32 x 8 General Purpose Working Registers
Up to 16 MIPS Throughput at 16MHz
Fully Static Operation
On-chip 2-cycle Multipl..
Performance and highlights:
Voltmeter wide range DC4.5 ~ 40V.
5V/2A output current (Only when the input voltage is 6.5 ~ 40V, it can output 5V).
A key ("Output Enable" button) switch USB output, a key ("low-power" button) to enter the ultra-low power.
Voltmeter can be artificial..
DESCRIPTION:
The Motor Shield is based on the L298, which is a dual full-bridge driver designed to drive inductive loads such as relays, solenoids, DC and stepping motors. It lets you drive two DC motors with your board, controlling the speed and direction of each one independently. You can al..
DESCRIPTION:
1.Electrical characteristics
The maximum output current: 2 a
The input voltage: 2 v ~ 24 v
The maximum output voltage: 28 v
Efficiency: ≤93%
2.Mechanical properties
product size: 36 mm * 17 mm * 14 mm
3.Method of use
The module of the IN+ and -..
DESCRIPTION:
The VIPer22A-E combines a dedicated current mode PWM controller with a high voltage power MOSFET on the same silicon chip.
Typical applications cover off line power supplies for battery charger adapters, standby power supplies for TV or monitors, auxiliary supplies for motor contr..
DESCRIPTION:
On-board XC2C32A chip.
On-board JTAG interface.
On-board 50MHZ active crystals.
With 4 programmable LEDs.
With AMS1117-3.3 and AMS1117-1.8 two kinds of LDO chip.
5V power supply with a switch.
All IO are leaded out.
..