16 Pin IC Base DIP Socket
An IC socket is used as a placeholder for IC chips and is used in order to allow safe removal and insertion of IC chips because IC chips may become damaged from heat or due to soldering.
..
Product Description:
LCD (Liquid Crystal Display) screen is an electronic display module and find a wide range of applications.
A 16x2 LCD display is very basic module and is very commonly used in various devices and circuits.
These modules are preferred ..
Product Description:
LCD (Liquid Crystal Display) screen is an electronic display module and find a wide range of applications.
A 16x2 LCD display is very basic module and is very commonly used in various devices and circuits.
These modules are preferred ..
DESCRIPTION:
The module is a 12-foot clock with 4 points of positive digital (0.36 inches) display module driver IC TM1637, only two signal lines can make SCM four 8-segment LED.
Module features are as follows:
Display of male red for the four digital tube
Adjustable di..
The 74HC164; 74HCT164 is an 8-bit serial-in/parallel-out shift register.
The device features two serial data inputs (DSA and DSB), eight parallel data outputs (Q0 to Q7).
Data is entered serially through DSA or DSB and either input can be used as an active HIGH enable for data entry through..
Features:
Single 8-bit Shift Register with Gated Serial Inputs and Asynchronous Clear
Fully Buffered Clock
Clock Frequency up to 36MHz
Operating Temperature up to 70oC
Standard TTL Switching Voltages
General Description:
These 8-bit shift registers feature gated serial inputs a..
DESCRIPTION:
Arduino LCD Keypad Shield
This is a 16x2 LCD and Keypad shield for Arduino Uno, Diecimila, Duemilanove and Freeduino boards.
Blue Backlight with white words
uses 4 Bit Arduino LCD Library
Left, Right, Up, Down and Select buttons
Scr..
Features:
High performance, low power Atmel® AVR® 8-bit microcontroller
Advanced RISC architecture
131 powerful instructions – most single clock cycle execution
32 × 8 general purpose working registers
Fully static operation
Up to 20 MIPS throughput at 20MHz
On-chip 2-cycle..
FEATURES:
Operating Voltage: 1.8 to 5.5 V.
Flash memory: 16 Kb.
EEPROM: 512 Byte.
SRAM: 1K.
I/O pin: 32 pin.
USART protocol interface.
I2C protocol interface.
SPI protocol interface.
APPLICATIONS:
It is used in Arduino boards.
It can also use in any AVR microcontroll..
The ATmega16A is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. It has 16K bytes of In-System Programmable Flash Program memory with Read-While-Write capabilities, 512 bytes EEPROM, 1K byte SRAM. By executing powerful instructions in a single clock cycle, the ATm..
Package Include:
1X ATMEGA328P 5V/16M + 3 x sets of header pins
Product description:
Mini Pro is a micro-controller board. It has 14 digital input / output pins (of which 6 can be used as PWM outputs),
&nb..
The CD4016 is a quad bilateral switch intended for the transmission or multiplexing of analog or digital signals. It is pin-for-pin compatible with CD4066B.Wide supply voltage range: 3V to 15V Wide range of digital and analog switching: ±7.5 VPEAK “ON” resistance for 15V operation: 400Ω (t..
DESCRIPTION:
This is a breakout board for the very handy 16-Channel Analog/Digital Multiplexer/Demultiplexer CD74HC4067.
This chip is like a rotary switch - it internally routes the common pin
(COM in the schematic, SIG on the board)to one of 16 channel pins (CHANxx).
..
Product description:
Brand new and high quality.
Voltage rating: AC 220V 50/60HZ.
Voltage limit: AC 180V-250V.
Hysteresis: 2 sec/day (25 Centigrade).
On/off operation: 17on & 17off.
Power consumption:7.5VA (MAX).
Display: LCD.
Service life: Mechanically 107.
..
FEATURES:
Supports 90~ 250V AC input
Support max 10A input
Power: 3500W(16A)
Support fast configure SSID and password connection through APP
Support automatic connect to server, register and update status info.
Support tracking device statu..
One side of the adapter board is SOP816 (1.27mm pitch) to DIP16 (2.54mm pitch), the other side is SSOP16 / TSSOP16 (0.65mm pitch) to DIP16 (2.54mm pitch). It is dual-side, unique design which can be compatible with more ICs.The 1x8P gold-plated pin header is durable, easy on the tin. After solde..
Description:
The HT16K33 is a memory mapping and multi-function LED controller driver. The max. Display segment numbers in the device is 128 patterns (16 segments and 8 commons) with a 13*3 (MAX.) matrix key scan circuit. The software configuration features of the HT16K33 makes it suitable for mu..
DESCRIPTION:
100% brand new and high quality
8 Bits. 8 keys. 8 LEDs. 8 digital tubes. common cathode LED digital tube.
With TM1638 Chip. this module gather more than three common SCM peripheral circuits.
The advantage is only three IO ports will be occupied when it drives.
SCM doesn't n..