DC-DC 600W 10-60V to 12-80V STEP UP CONVERTER

PARAMETERS:

• Module Name: 600W boost constant current module 
• Module Properties: non-isolated step-up module (BOOST) (not down)
• Input voltage: two selectable input voltage range, (by jumper selection board)

1. 8-16V input (for three strings of lithium battery and 12V applications)Enter in the state, do not exceed the input voltage, otherwise it will burn module !!!

2. 12-60V input factory default range (wide input voltage range of applications for)

• Input Current: . 16A (the MAX) more than 10A, please enhance heat dissipation
• Quiescent current: 15mA (12V liter 20V, the output voltage is higher Shizuta current will increase)
• Output voltage: 12-80V continuously adjustable
• Output Current: 12A 10A, please enhance heat dissipation than the MAX (input, output related to pressure, the greater the pressure the smaller the output current)
• Constant current range: 0.1-12A
• Output power: =Input voltage * 10A, such as: input 12V * 10A = 120W, input 24V * 10A = 240W,
•                           Input 36V * 10A = 360W, input 48V * 10A = 480W, input 60V * 10A = 600W
• Operating temperature: - 40 to + 85 degrees (ambient temperature is too high, please enhance heat dissipation)
• Operating frequency: 150KHz
• Conversion efficiency: up to 95% (efficiency of input and output voltage, current, pressure related)
• Overcurrent protection: Yes (input exceeds 17A, automatically reduce the output voltage, there is a range of errors.)
• Short circuit protection: Yes (input 20A fuse)   double short circuit protection and safer to use.
• Input reverse polarity protection: None, (if necessary please enter the string into the diode)
• Anti-anti-filling output: Yes, for charging plus blocking diode is not required.
• Installation: 2 3mm screws
• Connection: Terminal Free welding output
• Module size: 76 * 60 * 56mm (L * W * H)
• Single modules : 205 g

APPLICATIONS:

1. DIY a regulated power supply, input 12V can be, the output can be 12-80V adjustable.

2. for your electronic equipment, power supply, you can set the output voltage with your system voltage.

3. as the vehicle power supply for your laptop, PDA or digital products supply.

4. DIY a high-power notebook mobile power: coupled with large-capacity 12V lithium battery pack, so that your books where you can light to where.

5. the solar panel regulator.

6. to the battery, rechargeable lithium batteries.

7. drive high-power LED lights.

INSTRUCTIONS:

First, the input voltage range options: the default setting is 12-60V input, when you use the 12V battery or three strings, four strings of lithium, can put on the map with a jumper jumpered choose 9-16V input . 

Second, the output current adjustment method: 

     1, adjust CV potentiometer, according to your battery or LED, the output voltage is set to your desired voltage value. Such as 10 string LED voltage adjustment 37V, four strings of 55V and other adjustable battery. 

      2, counterclockwise CC potentiometer set around 30 laps, the output current is set to the minimum, connected to the LED, adjust the CC device to your desired current. For the battery charge, the battery discharge after power, and then received the output, adjust the CC to your current, (must be used to charge the battery when you want to put the battery to adjust the prospective, because the battery remaining in the more power More, the smaller the charge current.) Please do not use short-circuit way to adjust the current, boost the circuit structure of the module can not be short-circuit way.